Did you re-boot the computer? Sent from my iPhone ...nr4c. bill
> On Apr 12, 2019, at 7:47 PM, HB <[email protected]> wrote: > > Hey folks… > I have an unusual (I think) problem. I have a KX3 that I have used the KX3 > utility software with several times without issue. Today when I start the > software there is no COM port to select. In the bottom left hand part of the > KX3 PORT window is says Serial Port is Closed. (I’m using the Elecraft USB > cable for the KX3). > > I can’t get it to work. I can control my Kx3 with DXLabs using the COM port > no problem. I can use the Elecraft Frequency editor with no problem. I can > use WinLink Express no problem. But when I start the KX3 utility software I > can’t select a COM port – there are none listed. > > Here is my troubleshooting so far: > 1. I know the COM port is there – it works for other software > 2. I used the FTDI driver removal tool and uninstalled the FTDI drivers > 3. I uninstalled the KX3 software > 4. Reinstalled everything – but the issue remains > > Any ideas? > > PC: Surface Pro Laptop w/Windoze 10 > > Hank > K4HYJ > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
