Hi Jim,
even if you haven't changed any settings before I would check the COM
Port settings
like Baud rate etc. at the N1MM+
Check the settings at the K3S too.
Next should be the connection from K3S to PC. If you have another cable.
Give it a try
If you boot the PC make sure the K3S is already ON
73 de Chris, DL2MDU
Am 23.03.2019 um 01:15 schrieb KE8G:
Hi All,
Strange thing! I was working a DX station and my PC locked up, and kept
sending my call sign. The only way to stop the RF was to turn the rig
off. I let it sit for a minute or two, then turned it back on. The LCD
screen flashed a ERR PTT. I disconnected the WinKeyer and plugged it back
in and was able to work the station with the paddles, rather than N1MM+
Now, I can't get the K3s to connect to the PC (Win7 Pro 64bit). It shows
as a unrecognized USB device in the Device Manager.
I have shut everything down, PC, K3s, WinKeyer and removed power from all
and let it sit for awhile. The PC starts fine, the K3s starts up fine (no
ERR messages) and works well, the Winkeyer works fine.
I know the K3s was communicating with the PC earlier, as I was using the K3
utility to set roofing filters I just installed in the sub receiver.
Any suggestions on where to begin looking would be a great help.
Thanks in advance.
73 de Jim - KE8G
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
