I can easily attest that all the grounds are bonded together in the panel. Everything related to the station is on the same strip with a 0 ohm potential to the ground rod Sent from Yahoo Mail on Android On Sun, Dec 30, 2018 at 8:32 PM, Jim Brown<[email protected]> wrote: That's not nearly enough. EVERYTHING in your home must be bonded together -- power, telco, CATV, your antennas, and all ground rods. Two places to learn it -- N0AX's recent ARRL book on grounding and bonding, and my own tutorial, upon which much of Ward's book is based.
http://k9yc.com/GroundingAndAudio.pdf Also -- as noted in my tutorial, EVERYTHING connected with your station, including computers and other accessories connected to your rig) should get power from the same outlet, or from outlets whose green wires (third pin) are bonded together in your shack. This is just as important as bonding. 73, Jim K9YC On 12/30/2018 4:13 PM, Ken B via Elecraft wrote: > Good evening The Icom IC-7600 KAT500, and KPA500 are each grounded to a > single terminal strip with a #10 cable directly to a ground rod 15 ft away. > The rod is 12 ft deep. Both the KAP and KTA were factory built as my > soldering skills have diminished since the Army training. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
