I use HRD to control my rig on data modes and it does a good job and works as expected. However, if the K3 display is set to show the REF*CAL situation then after transmitting the rig stays in transmit mode, as shown by the red TX button being lit. I have not noticed this when the K3 display shows other information such as the current being drawn. Is this to be expected?? G4HUE Andy
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
