How does one know what "BAND" the K2 is set for?
Hi Fred,
The K2 firmware does have a notion of what band you're on. The way
*you* can tell (usually) is to look at the VFO frequency. However, it
is possible to tune outside the normal band limits, possibly even into
the next band's territory. If you do that, you'll notice that the
receiver sensitivity will get a lot worse. But in any case, the way to
get back to the correct band is to do "direct frequency entry,"
described in the manual.
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
