Hello to the group. I have downloaded both the KAT500 and KPA500 remote software. I am using them at my remote site. I have a Windows 10 computer that I can access via Anydesk or Teamviewer.
I am unable to connect to either program in a Server/Client combination. I keep getting a message that "failed to connect". What I have done so far is: I am able to Ping the host PC from a couple of other computers within the same network. I am able to get the programs working if I connect directly to the remote computer (using either the Host IP address or local host) I temporarily disabled all firewall programs on all computers I cannot connect from 2 separate computers on the same network (Windows 7) At the remote site I have an ethernet switch that I connected to directly and was still not able to access the computer about 5 feet away I have made sure that the port has been opened in my DSL router (although when using the same network I realize that this is not required) I have the latest firmware in both the KPA500 and KAT 500 Not quite sure what I am doing wrong. Any assistance would be greatly appreciated as I am presently at the remote site for the weekend. 73 Serge VA3SB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
