Hi Don, thanks for your answer and the idea to use macros.
At this time I use KX3 utility to setup a macro for testing. E.g.: Macro 2: CWINSSB DELAY;MD3;DELAY;DELAY;KS014;BW0240;SWT11;SWT19;MD2; Starting mode: SSB: switch to CW, Keyer speed 14, bandwith 2.4kHz, Key MSG and Key 1... then back to SSB. Due to the "CW Text to send"-time the MD2 is ignored and I do not like to set "random" DELAYs to get MD2 working, depending an keyer speed. Any suggestions? Kind regards, 73 de Martin, DL1MTG 2017-07-28 0:15 GMT+02:00 Don Wilhelm <[email protected]>: > Martin, > > Yes, the CW memories will not work well with CW in SSB. > Input from the paddles or hand key should work fine. > > If you must use the CW memories, you must switch to CW mode and set the > frequency above or below the SSB frequency. Perhaps a macro could be > created to do that with one button push, and another to go back to SSB. > > 73, > Don W3FPR > > > On 7/27/2017 8:39 AM, Martin Theodor Grewe wrote: > >> Hi Don, >> >> thanks for your answer and Explanation. CW WGHT is known but not helpful >> in this case. >> >> I'll try to explan: CW WGHT is set to 800Hz. I'am operating in USB, using >> CW-In-SSB. I can answer the station. >> But station cannot read my signal, I try to answer with an stored CW >> Memory because I am lazy. Now I have to >> change mode from SSB to CW to get CW Memory ... and so on with the next >> SSB-session answering a cw Station again. >> >> This is, for my understanding, a bit too much: Change mode, activate cw >> keyer etc. >> >> Its easier to have "Extended CW memories" only for CW-IN-SSB in SSB-mode. >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
