Fellow Elecrafters--
I've successfully completed the KSB2 module for my K2/100 through p. 16
in the manual, front panel PCB component installation.
Now it's time for mic configuration, p. 17. Winding toroids, soldering
multi-pin connectors and IC's, stuffing capacitors, etc.--those I don't
mind. However, when it comes to mic configuration and the possibility of
fouling up my K2 via an incorrectly-wired 5V line--that's when I get
jittery.
Here are the details:
1) Initial mic to be used: Kenwood MC-60
2) Eventual mic to be used: Radio Shack RS 33-1187 headset
3) P1 wiring method: N0SS's computer plug (thanks for the info on your
website, Tom) or two-pin jumpers--both are at hand.
After studying the KSB2 manual and reading postings in the Elecraft
reflector archives, here are some questions:
1) Several reflector postings mention that for Kenwood settings, just use
jumpers straight across for all the "Signal" and "Mic pin" connections.
However, on p. 18 under Kenwood mics, there's a note: "Do not connect
pin 5 unless mic has internal preamp," and another, "Leave pin 6 of the
mic unconnected."
I plead ignorance--does the MC-60 have an internal preamp? If it does,
according to the manual I should connect signal pin 6 to mic pin 5.
2) I've read a posting that mentions leaving the bottom slide switch on
the MC-60 "off." Done. Wonder if this negates the warning listed above
and I should just leave signal pin 6 ("5V") unconnected?
3) The MC-60 has two impedance settings, 50K and 500--is there a
preferred setting with the K2?
4) Any suggestions for wiring an 8-pin female mic plug from the RS
33-1187 that'll be compatible with Kenwood P1 settings?
Finally, it's been mentioned before but for those who need it here's the
Radio Shack part number for a package of ten two-pin jumpers: 276-1512.
73,
John, N7ON K2/100 S/N 5023
P.S. Many thanks to Elecraft's Gary and Richard as well as to N6WG and
WB6TQG for their continued assistance with the KSB2, microphones, and
RTTY.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
