Hi Gary,
Sorry for the delayed response to your question. I was away from email
for a long weekend (hooray!). I don't have a KX1, so I don't know
exactly, but I do have a CMOS-4 (and an Elecraft K2). The CMOS-4 uses an
RCA jack for the key output. To interface my K2 to my CMOS-4 keyer, I
took an RCA patch cable, cut off the RCA connector on the end, and
soldered a 1/8" stereo plug instead. Of course the cable ground shield
should be connected to the RCA ground shield on one end and the stereo
ground shield on the other. I can't recall if the inner connector from
the RCA plug should be connected to the tip or the ring of the stereo
plug, but I suspect it doesn't matter.
73,
- Rob W7GH
K2 #5004
On Sat, 25 Mar 2006 14:03:27 -0800, Gary H Evans
<[EMAIL PROTECTED]> wrote:
I would like to use my CMOS-4 keyer with my KX1. Can anyone help with
the wiring of the cable between the keyer and the KX1? Thanks...Gary -
AA6R
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
