Oh and btw, Fred,
This is on the same page;
<quote>
Locate the Spacer Set PC board (Figure 5-1). Using long-nose
pliers, carefully break out the pushbutton switch spacing tool and
the four backlight LED spacers. Break the material only at the four
indicated points. Note: The switch spacing tool doubles as the PC
board for the RF probe, which will be assembled later.
<unquote>
73,
Peter
----- Oorspronkelijk bericht -----
Van: "PAøPJE" <[EMAIL PROTECTED]>
Aan: <[email protected]>
Verzonden: zaterdag 25 maart 2006 17:47
Onderwerp: Re: [Elecraft] LCD Diffuser SPACERS? K2 # 5422?
Fred,
They are part of the pieces PC board that is seen in fig. 5-1
That is the switch spacing tool. Part of it are the spacers.
73,
Peter PA0PJE
F and J schreef:
I'm building K2 #5422, doing Front Panel board now!
I seem to be MISSING the two (2) 3/4" (19mm) LONG
SPACERS mentioned on page 26, for putting over leads
of each backlight LED shown in figure 5.9?
No were to be found, as far as I can see. WHAT DO
THEY LOOK LIKE? Paper? Plastic? Temporary?
Home made?
There are no "spacers" mentioned in appendix of
photos for this Front Panel PCboard either?
Help
Thanks, 73's
Fred N3CSY
Spring Hill, FL
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com _______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
