Tom,
If it were not for the addition of your loop control box, you would set
both the KXPA100 and the KX3 to the 38.4 rate.
But take a look at the baud rate requirements for your loop control box.
If it will handle 38.4k, then all is well, but if it requires a lesser
baud rate, set both the KX3 and the KXPA100 to that baud rate.
73,
Don W3FPR
On 11/4/2016 10:34 AM, Thomas Beltran wrote:
Hello John and thanks. Should I figure out what the baud rate of the kx3 is
(since that works) and then set the kxpa100 to match?
-----Original Message-----
From: Elecraft [mailto:[email protected]] On Behalf Of John
Pitz
Sent: Friday, November 04, 2016 7:23 AM
To: [email protected]
Subject: Re: [Elecraft] KXPA100 RS-232 problem
It is likely a RS232 speed issue like Dick Dievendorff said. Something else
you may want to do is change the KX3 baud rate to match the KXPA100. The
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
