.1? Sent from my iPhone ...nr4c. bill
> On Nov 2, 2016, at 10:28 PM, Gerard Elijzen <[email protected]> wrote: > > Hi all, > > Using the Kx3 utility Command tester Revision 1.16.6.25 on my MacBook Pro I > noticed the following: > > Issued command PC001; results in 1W > Issued command PC005; results in 5W > Issued command PC010; results in 10W > Issued command PC015; results in 15W > Issued command PC011; ALSO results in 15W. Could this be a bug perhaps? > > Also, how does one issue a command to set the power level to 100mW or 500mW. > > The current KX3 Programmers Manual under the PC command states that the range > is from 000 to 012 and 015 but this is not the case. Also the power levels in > this section are incorrect for the given bands. They should be reversed: > 80-20m = 15W and 160/ 15-6m =12W. > > > My main question is: Using the PC command, how do I set the power level to > 100mW? > > Thanks, > > Gerard VK2JNG > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
