Nope, its around #4400.
So will have to look elsewhere.
Thanks,
Rich
----- Original Message -----
From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: "Elecraft Reflector" <[email protected]>
Sent: Sunday, March 19, 2006 9:02 AM
Subject: RE: [Elecraft] Problems on 40M with 100 watt section
The problem with the resistors Vic mentioned was a short-lived problem
that
reared its ugly head last Summer until the Elecraft folks discovered that
the resistor manufacturer had changed the resistor design, so if your
KPA100
was not kitted during that timeframe, you should look for another source
of
the problem.
73,
Don W3FPR
-----Original Message-----
Rich McCabe wrote:
> Time to search the archives. Any comments would be appreciated.
There is a possible problem with some of the resistors that have been
supplied for R19/R20 having a larger than usual inductance; and also
some capacitors at C80/81 being at the low end of tolerance. This
causes the KPA100 to require much more drive on 20/30/17 meters. You
will see normal current draw at 10 watts, but when you have the
amplifier set for 100 watts the driver current will be higher, and it
won't be possible to get full power out.
Gary Surrency <[EMAIL PROTECTED]> has dealt with this problem and can
make suggestions.
Good luck,
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
