I have been reading these messages about the drift and or change of frequency when you move the K1. So, I just turned my K1 on for a few minutes and it is just as solid as a rock. I turned it upside down and moved it around but no change in frequency. I figure I should be happy about that!! Paul Gates, KD3JF Elecraft Kits: K1 #0231 KX1 #1186 XG1: Signal Generator
----- Original Message ---- From: Mike Morrow <[EMAIL PROTECTED]> To: Elecraft Discussion List <[email protected]> Sent: Thursday, February 23, 2006 6:41:46 PM Subject: RE: [Elecraft] Drift-K1 >My K1 is very sensitive to placement. If I pick it up or turn it upside >down, I can hear it shift up or down in frequency. Anything that squeezes or otherwise distorts the K1 bottom cover plate (such as when the case is grabbed during repositioning) will cause a small frequency shift (I see well below 100 Hz), due to the change of metal bottom cover plate position near the LC VFO circuitry on the RF PCB. The frequency returns to original when the pressure is released on the bottom cover. 73, Mike / KK5F _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
