Hi Ron, Sending
K22;PC005; will set the KX3 to 0.5 watts (for example). The trick here is using the "K2" meta command, originally written for the K2. The default is K20 mode (no modification of commands). But if you send K22; then some commands will behave differently, including the PC command, which goes from 1-watt increments to 0.1-W increments. K22 mode also adds a 4th digit to the PC command. What this does is left as an exercise for the reader. (See the K3S/K3/KX3 programmer's reference.) 73 Wayne N6KR On Sep 11, 2015, at 8:36 PM, "[email protected]" <[email protected]> wrote: > Is there a programming command to set the KX3 power to less than one watt? > PC001; seems to be the lowest level you can get, according to the programming > guide. > The NAQCC sprints often use power levels that must be less than one watt, > which means a manual setting on the front panel. > > I love macros !!! > > Ron W7HD > -- > OMISS#9898 Linuxuser#415320 NAQCC#7587 > My homepage: http://w7hd.net > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
