Frank,
I use the KPA100 with my KX3 and my K2 and it works fine. I replaced the
MCU of the KPA100 with a PIC16F876A with my own firmware. The KPA100 is
controlled now via its serial port (homemade communication protocol) by
PC or an homemade interface (display and controller with serial port).
Hardware changes in KPA100 are minimal.
But, in all not so easy as it may sound. I aree with Don W3FPR and
recommend a KXPA100.
73, paul
hb9axl
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
