Yes, I went back and looked and I had it turned up too high
Thank you

      From: Alan <[email protected]>
 To: [email protected] 
 Sent: Thursday, January 8, 2015 8:36 PM
 Subject: Re: [Elecraft] P3 and the Nose Blanker an observation
   
Also it is important to set the noise blanker level to the minimum that 
eliminates the noise.

Alan N1AL

On 01/08/2015 04:00 PM, Harry Yingst via Elecraft wrote:
> I noticed something on the P3 and maybe it's a known thing.
> I turned on my Flex-1500 that had been sitting idle for nearly a year and 
> noticedthat the display looked far sharper than the P3's display (Signals 
> more distinct).
> Then I discovered what I was seeing... I had the noise blanker on the P3  
> turned on.When I turned off the noise blanker the display looked clear and 
> distinct again.
> So It appears that the noise blanker algorithm is averaging the signal to 
> remove the noise.
>
> Just an observation and something to remember to turn off when not needed.
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to [email protected]


>
>

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]


  
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]

Reply via email to