Trying to put together K2 #5278 I am at the point for alignment and test Part 1. Powers up fine and shows 7100.00 c and display shows correct voltage and amperage. But when I test the optical encoder by turning the vfo knob it moves from 7100.00 c to 7100.01 c and then upon further turning moves back to 7100.00 c. Does the same thing no matter which way the knob is turned. Rechecked components and solder joint without finding anything. I may just be too old for this solid state stuff. I think the last thing I built was a HW 101. I did not try to go on to the calibration part as it may not be worthwhile with the encoder not working correctly.
Appreciate any suggestions. K2 #5278 Ed Findley WB2KUI _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
