Happy new year all!
I am looking at the PLL Frequency Stability at 7182
kHz sheet which says "Alternately insert the internal
counter probe into TP1 (VCO) and TP3 (PLL reference
oscillator) and make sure they indicate the same
frequency (in the 12 mHz range)."
Here are my frequencies:
TP1: 12092.59
TP3: 12097.64
That is a differenct of 5.05.
Is this okay, or do I have a problem?
If it is a problem, what should I do about it?
I already recalibrated C22 on the control board and
ran the VFO linearization.
Thanks for your help!
73,
Vron Jones, WD0EFQ
__________________________________________
Yahoo! DSL Something to write home about.
Just $16.99/mo. or less.
dsl.yahoo.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
