Jorge,
If you are talking about the K3 IF output, there is nothing to activate.
Connect a known working receiver tuned to the K3 IF frequency of 8.215
MHz and you should be able to hear the same signals as the K3 is hearing
- you may have to tune a couple kHz in either direction to find it, but
the signal should be present.
If you have a signal generator connected to the K3 input, the signal may
be easier to find because it should be the only signal present.
If you have an older K3 (prior to September 2009), you will likely want
to add the IF Output Buffer Gain Modification which increases the signal
level at the IF output by more than 10 dB. See
http://www.elecraft.com/K3/mods/IF_Output_Buffer_Gain_Mod_Rev_A.pdf
73,
Don W3FPR
On 7/26/2014 5:52 PM, Jorge Diez - CX6VM wrote:
Hello
Is there any CONFIG to activate IF OUT?
I connected a SDR-IQ to the IF OUT but nothing happens, maybe I need to
activate some functions?
Thanks,
Jorge
CX6VM/CW5W
---
Este mensaje no contiene virus ni malware porque la protección de avast!
Antivirus está activa.
http://www.avast.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
