I had a similar event. It took out my Yaesu rotor and control box, SteppIR controler board, and my KAT500. Like you, my K3 and KPA500 wre A-OK I sent KAT500 to Elecraft for repair and mine acted just like yours. (you must get an authorization # before sending). It was DOA @ Elecraft and cost of new board about equal to a new KAT500 - bummer. Good luck, I'm installing polyphaser's on SteppIR and new Yaesu rotor control lines this week. 73, Cary, K4TM Lynchburg VA K3-100 #3448, KPA500 #698
Sent from my iPhone in Lynchburg VA. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
