I know we aren't suppose to do the 'me to' kind of posts here
and before hundreds of others add theirs and the topic gets canned
(again)...
as far as I am concerned this is the only remaining 'feature' that ruins
an otherwise perfect station combo.
perhaps the Flex is worth looking at again if this is never going to be
addressed??
On 9/24/2013 9:11 AM, Gary Gregory wrote:
Your not alone...:-(
On 25 September 2013 00:09, Bob <[email protected]> wrote:
So I've been loving my P3 for about 2 years now, and I keep looking at that
lonely sensor window in the back, dreaming and wishing....
Yesterday I received an email from a ham a few thousand miles away asking
me to clean up my signal -- I was running JT65 at the time, and he saw my
signal decode on his rig in a half-dozen spots across the waterfall. I
panicked, of course, and immediately checked everything -- Line Level was
four bars steady with an occasional fifth bar flickering, transmit power
was 5.0 watts, monitor was sounding perfectly fine, and my handheld
receiver was sounding OK too. Later that night a nearby ham was nice
enough to run a spectral analysis on my signal and found it looked clean as
well.
Imagine how easy it would be for me to verify my outbound signal quality if
my P3 had an outboard RF sampling tap that communicated via IR back to the
P3 and allows the outbound RF to be displayed.
One can dream and wish.
73, Bob, WB4SON
--
GB & 73
K5OAI
Sam Morgan
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
