That control acts normally. I can set the power from 0 to 100+ watts, and the green light is on. After the calibration run, power = 0.0.briefly flashes up, and then it goes to where I had the power set before the run --- 5.0 watts in my case.
*Brian F. Wruble, C.F.A. *70 is the new 40.* * Mail: 1107 Key Plaza, PMB 447 Key West, FL 33040-4077 Summers: P.O.Box 57, 7400 Augustine Herman Highway, Georgetown, MD 21930 eFax 305.768.0278 On Sat, May 25, 2013 at 9:59 PM, Ed <[email protected]> wrote: > Brian > > What does the display show when you manipulate the power control knob. > It must have the green LED lit indicating “PWR” above the knob. If I > remember correctly the calibration process will set the output to “0” after > calibration. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
