On Sat, May 25, 2013 at 10:54 AM, Brian F. Wruble <[email protected]> wrote:
> Somehow I broke the connector J92. The center pin broke flush with the
> board while I was inserting the coax connector.
>
> What is my next move?
>
> I thought that line was needed only if I want to use the external BNC
> connector for "receive only" on the sub-receiver. However, I seem to have
> no signal in the KRX-3 --- S meter zero, just noise. There is somthting
> about this I don't understand.
>
> I am prepared to do without the BNC connector option. How do I get the
> sub-receiver working? Is there something I have setup wrong?
Did you follow the manual section on "Sub Receiver Antenna Selection" ?
Broken J92 shouldn't matter if you don't want to use the AUX BNC input.
73,
~iain / N6ML
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
