Found it...does N1MM have a mind of its own?
Found the CQ repeat enabled..and there is no reason for me to even check
that off......
----- Original Message -----
From: "Jay" <[email protected]>
To: <[email protected]>
Sent: Friday, May 24, 2013 4:22 PM
Subject: [Elecraft] XMIT Cycling in K3
After loading the new released files today with the new utility (all went
fine) for the K3, when I now use N1MM and call CQ it keeps on cycling the
CQ (XMIT to RX and then again XMIT over and over)..just keeps on looping
until I hit escape in N1MM
This occurs in CW and RTTY modes
Never did this before
HUH?
Jay
W2IJ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
