Thanks, Matt,
I purchased an XG50 at the time I purchased the KX3. I remember running
a procedure with the KX3/XG50 but it was nowhere near as involved as the
one shown in the referenced manual.
I will run the new procedure and let the list know how it went.
73,
Jim - W4BQP
On 3/27/2013 6:50 PM, Matt Zilmer wrote:
Hi Jim,
You might want to run the temperature compensation procedure on your
KX3. If it's performed correctly, you should see < 2 Hz drift over
the temperature range. You may want to purchase the XG50, used as a
stable frequency referece, or you can supply your own.
The procedure is shown in this document:
http://www.elecraft.com/manual/KX3%20Custom%20VFO%20TC%20rev%20A9.pdf
73,
matt W6NIA
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
