Bruce,
The KAT100 draws very little current after it has tuned, so it will not
add much of a load for normal operation.
The KPA100 sets the tuning power at 20 watts, so there is plenty of
current left over for the KAT100 tune cycle.
The nominal draw of the KPA100 is about 17 Amps at 100 watts, so your 20
amp supply should be sufficient for both.
73,
Don W3FPR
On 3/9/2013 8:41 AM, K1FFX wrote:
Mike and Don -
Thanks for your replies. I use either an Astron 20 or the MFJ-4125 (about
22 amp
switching supply) with the K2/100, usually running at the 100 watt output
level.
Sure would be great if one or both supplies would be adequate for running
both the rig
and the KAT100. Your thoughts?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
