Mark,
It is good to hear that the resistor solved the problem.
If you had to add a pull-down resistor, that is not a K3 problem, that
is a requirement of whatever in your sequencer that is driving the K3 TX
INH line. In other words, whatever is driving your TX INH line is not
going to zero volts quickly enough.
Since you have several units diode ORed for TX INH, it could be any one
of them causing the situation.
It is nice to hear that you have found a solution.
73,
Don W3FPR
On 1/26/2013 5:37 PM, Mark n2qt wrote:
My TxInh circuit diode or'd various inputs together. What I did not do
is put a
resistor to ground after the diodes. The K3 TxInh input does not have
a pull
down, and has a high enough impedance that there is an appreciable time
delay before the TxInh coasts down to where it allows the K3 to transmit.
Adding the resistor makes everything ok again...
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
