IMPORTANT ADDENDUM/CORRECTION TO MY PREVIOUS POST ON THIS. I wrote: > Take your ohmmeter and measure from the center, where the adjustment tool > contacts the capacitor. Measure to each of the two contacts, and find the > one that is shorted to the adjustment slot. That is the side you want to > be grounded after install. Next, look at the board, and see which hole for > either C1, C2, C5, C6, CA, CB, CE, or CH are connected to the ground plane > of the board. That is hole that you want the lead that you just identified > to end up in. The trimmers are all oriented the same way.
The trimmers DO NOT all mount the same way! You must look at the assembly instructions for the KFL1_4 board, and take note of how the trimmers mount. On my manual, it's page 17. Compare the drawing with the trimmers you have, to determine the proper orientation of each, once you know which side on yours corresponds to the "flat" side in the drawing. Again, you need to determine which side of the cap is connected to the center adjustment screw. That is the side you want to be grounded. Compare that with the board, and see if that corresponds to the "flat" side on the original trimmers, or the other side. I don't have a board here to check. Once you know how your trimmers compare to the original ones pictured in the (fig 11), you can then orient all your trimmers accordingly. Sorry for the mis-information in my original reply, and good luck, Bruce, N1RX ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
