GM Tim: I also have my PR6 connected using a pair of Male-Male BNC
adapters - I'm using Amphenol and have never experienced the problem you
speak of. The part number in the 2011 DigiKey catalogue is ACX1062-ND @
$6.32 each (pg 456)
Hope that helps.
73, Doug VE3MV
----- Original Message -----
From: "N3XX" <[email protected]>
To: "Elecraft Reflector" <[email protected]>
Sent: Wednesday, December 19, 2012 10:10 AM
Subject: [Elecraft] [K3] PR6 to RCV ANT - BNC Connectors
Hi all,
I'm using a PR6 preamp (switched on by DIGOUT1 from the ACC connector when
I'm on 6 mtrs) connected to the K3 receive antenna connectors with a pair
of male-male BNC connectors. I have been having a problem with audio
levels dropping as much as 15 dB (as seen on WSJT Specjt window). This is
always corrected by unplugging the male-male BNC connectors from the
receive antenna connectors on the K3 and plugging back in again. I'm
hoping the problem is just the male-male BNC connectors I'm using to
connect the PR6, and not the connectors on the K3. Has anyone else seen
this problem, and have you found a good brand of male-male BNC connectors
that corrected the problem? If you have been able to correct this problem
with good male-male BNCs, what brand are they, and where did you get them?
Thanks for any info.
73,
Tim - N3XX
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
