I installed 8 new Lithiums in my KX3 just to try them out…. 15 bucks… Yep that first set worked just fine. I used them for a few weeks off and on listened to am short-wave made cw and ssb contacts more or less for a few weeks. FB the voltage hovered above 12 volts in the Rx mode… No problem. I am happy. Today they gave up the ghost. The KX3 huffed and puffed and shut down :) Time to swap out the old for the new. Cracked open a brand spanking new set (8 to a pack) and shoehorned them into my KX3 rig. ahhh fresh juice I thought to myself… Maybe I'll do a few QSO's on 21 since its been kinda good. Within 5 mins the voltage is at or below 12 volts… WTF! Is my radio messed up???? no… Pulled the battery and measure the voltage of each cell… 1.614 +/- on a lark I measure the Old ones… 1.591 +/-….hummmm but in the old 8 pack there was one battery that measured 1.214 +/- volts…. Hummmm Seems the new batteries are bogus… I will call the Energizer Hot line in the AM and see whats up. 800 383 7323 So beware of bogus Lithium batteries… checked Amazon battery reviews and saw some folks are having problems with crappy lithiums…. hummmm I smell a rat. Phil K5SSR If you don't know what it is... Don't poke it... Santa Fe
K5SSR If you don't know what it is, don't poke it. On Nov 19, 2012, at 10:27 AM, wayne burdick <[email protected]> wrote: > K3 beta-test firmware revision 4.60 (with DSP rev. 2.80) is now > available. See release notes below. > > Please send any questions to [email protected]. For beta firmware > download instructions, see: > > http://www.elecraft.com/K3/k3_software.htm > > 73, > Wayne > N6KR > > * * * > > MCU 4.60 / DSP 2.80, 11-17-2012 > > * ESSB TRANSMIT CAN USE THE FM FILTER: The wide (FM) crystal filter > can now be assigned to ESSB transmit as well as FM and AM. This can > potentially free up a crystal filter slot for customers who were using > the 6-kHz filter only for AM or ESSB. NOTE: The 6-kHz filter is still > recommended for high-performance ESSB and AM receive, as it will > provide significantly better close-in dynamic range than the FM filter. > > * TRANSVERTER FREQUENCY ENTRY FIXED: The previous firmware release > did not handle direct frequency entry to transverter bands correctly > (e.g., 144 MHz came out as 180 MHz). This also affected memory recall > of transverter bands. > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
