Having the 1 setting so low will also make your signal mushy and hard to understand. Remember, commercial broadcast quality will widen your signal and make it difficult to understand in conditions where the atmospheric noise level is above normal.
Amateur Radio Operator N5GE ARRL Lifetime Member QCWA Lifetime Member On Tue, 14 Aug 2012 22:54:46 -0400 (EDT), Scott Dunlavey <[email protected]> wrote: >Hello agn... I cant figure what I have set wrong... I have set up the >eq on the K3 in transmit the following way... 1=+12 2=+10 3=-1 4= >-1 5= 0 6= -1 7=0 8 = +2 Rx is the same.... (this is how I had it >set for the w2ihy EQ...) as I am trying to set the mic gain and >monitor levels I get a lot of feedback in my headphone.very loud.. My >monitor level is very low... compression has NOT been adjusted because >of the feedback so that is at zero.... I have a heil pro20 running to >the front of the K3... any ideas > > >scott >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
