Steve, The frequency calibration is in the manual.
Refer to the KX3 manual beginning on page 31 to calibrate your reference frequency.. That procedure should achieve an accuracy better then +/- 1 ppm. 73, Don W3FPR On 7/14/2012 10:09 PM, Steve KC8QVO wrote: > Here are some more numbers: > > FT857D / KX3 > 160: 1800 / 1801.18 > 80: 3.500 /3.502.35 > 40: 7.000 / 7.004.76 > 30: 10.100 / 10.106.88 > 20: 14.000 / 14.009.55 > 17: 18.100 / 18.112.37 > 15: 21.000 / 21.014.36 > 12: 24.900 / 24.917.1 > 10: 28.000 / 28.019.18 > 6: 50.100 / 50.134.32 > > These were all measured on CW. I have a service monitor back home so I have > a better reference to use, just not with me right now. If there is an > alignment procedure that would be a big help. > > Steve, KC8QVO > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/KX3-Calibrating-Frequency-Aligning-tp7559098p7559113.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
