My K2 has recently been repaired after a polarity reversal of amp connected to it blew out the bnc connector. It works all OK, except that when I switch the display to show Volts/current, the current stays on i0.00. I have checked the current sense resistor voltage drop is OK for both RX and TX, and the voltage is showing at control board MCU pin 4 ( current sense input). (0.013 volts RX, 0.11 volts at 10W TX).
So at this point I'm stumped. Faulty MCU chip? Any advice on/off the forum would be appreciated. Chris VK2ACD Email sent using Dodo Webmail ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
