Hi Mike, What is CONFIG:TX DLY set to? 73, Guy. On Fri, Jun 8, 2012 at 12:41 AM, Michael Marx <[email protected]>wrote:
> Hey all, > > I just built my new K3-100. All seems to be fine except when I try to > use CW QRQ mode. When I select this mode, I only have about 5 watts of > power output no matter where the power setting is. Elecraft says that the > CW QRQ mode has nothing to do with power output, yet I have the problem. I > am using the built in wattmeter and an external wattmeter. When I switch > CW QRQ off, the power comes back to full. I did a reset at Elecraft's > recommendation and it did not resolve the problem. I also loaded the > newest firmware (which it should have had anyway) and no solution to the > problem. Any ideas out there > > 73, > Mike WB0SND > > Michael Marx > [email protected] > > www.vacuumtubes.com > SND Tube Sales > 105 N. Division St. > Bonne Terre, MO 63628 > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
