No problem at all my friend !!! Amateur must share knowledge !!!
73 and thanks !!!
Le 05-08-10 à 20:11, Gary Hvizdak a écrit :
Hi J-F,
I like yours much better than Mark's original. May I have your
permission to use it on our website?
73,
Gary, KI4GGX
K2 #4067
-----Original Message-----
From: JEAN-FRANCOIS MENARD [mailto:[EMAIL PROTECTED]
Sent: Wednesday 10 August 2005 1915
To: Gary Hvizdak
Cc: Elecraft - Mailing List Elecraft - Maling List
Subject: [Elecraft] Homebrew un-mod kit... KNB2 revised !!!
Hi,
After Gary (KI4GGX) recommandation and explanation, I finally redo
from scratch the KNB2 jumper... Yes in deed, it was a little bit
harder to do. I should be able to keep the clearance at about
1/2"... I hope. ;-)
I did a photo of the jumper before applying tape and sticker. And I
use one 560 Ohm resistance instead of the 470 Ohm.
http://homepage.mac.com/jfmenard/PhotoAlbum29.html
Thanks again Gary !
73
J-F / VA2VYZ
Elecraft K2 #4130 / KX1 #999
======
Jean-François Ménard / VA2VYZ
======
======
Jean-François Ménard / VA2VYZ
======
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
