It is being sent to P3 owners who also ordered the P3SVGA. It is the increased current drain of the P3SVGA board that makes this mod desirable/required.
I installed mine today, and it works fine. (did it without removing the KPA3, but many will want to do that. One issue with the instructions is that they have you remove the fan panel, or the blank panel if you don't have the KPA3. What is not taken into consideration is if you also have the K144XV installed, with it's ANT3 connection on the fan panel. The instructions do not tell you to remove the ANT3 cable/connector. I was able to do the mod (carefully) without completely removing the fan panel, just loosening the screws. The instructions also never tell you to re-install the bottom rear panel, but I imagine most ops will remember to do that... 73, Bruce, N1RX > Is the mod kit something that needs to be requested from Elecraft or is it > being sent to P3 owners? > 73, Alan N5NA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
