Yes, it's just three screws to get the KPA3 module out and makes it much, much easier to reach the parts without damaging anything, especially if you have the KAT3 installed.
73, Ron AC7AC -----Original Message----- I just received this kit which increases the current available at the 12V DC Out jack on the K3 to drive a P3 with P3SVGA. The kit consists of replacing a surface mount diode, a through hole fuse and through hole choke. Elecraft sent me this kit without my asking. :) I have not installed it yet but the diode is accessed by removing the bottom panel. The fuse and RFC replacement require removing the top cover, fan assembly and the KPA3 module (optional but recommended). The new fuse is rated at 1.1 amp. I expect to do the install tomorrow and will report back then. Lou W2ROW ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
