I am constantly disassembling/reassembling my K3 station because of lightning. Disassembling is pretty easy "blindfolded". I move the K3 forward to be sure everything is disconnected.
To reassemble: --Put K3 on right side feet --Attach 3 antennas (ANT1, ANT2, and Aux for second receiver) --attach power pole, ground wire --Attach key and paddle, KeyOut wire to amp. --attach external speakers --Place K3 normally --attach IF output, Line In, Line Out --Attach 2 DIN connecters, (ALC is only signal I use) and serial port --attach microphone That's 15 connections. Having a routine makes it go faster and best assures nothing is missed. Monty K2DLJ On Mar 25, 2012, at 7:03 AM, Pete Smith N4ZR wrote: > Or you can put one of those mirror tiles against the wall behind your > radio. That said, I would give almost anything for enough room in my > shack to have a 24 inch walk through behind my station. > > 73, Pete N4ZR > > On 3/25/2012 6:14 AM, Bill W4ZV wrote: >> Pierfrancesco Caci wrote >>> Pulling out the K3 is sort of doable, but putting it back in >>> position is a real pain. >>> >> This mirror image of the rear panel may help: >> >> http://www.n5na.net/download/k3_rear_panel_mirror.pdf >> >> 73, Bill >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
