Dave, Your amp kit was shipped quite a while ago... At that time, Elecraft was in the process of converting from 4-40 x 5/16" black flathead machine screws to 1/4" for attaching the Z-bracket and left side panel to the heat sink.
If you don't have enough 5/16", you should have extra 1/4". Perhaps in the "Hardware Spares" bag. If not, please reply to me and I'll have them shipped to you. Regards, Bob Wolbert On 3/19/2012 7:16 PM, Dave Anderson, K4SV wrote: > Hi All, > > Thought I would bounce this question off those who have assembled the KPA500. > > I am building Serial #439 > > I am at page 22 where it says to install 5 - 5/16" Black Flat Head screws in > the plate attached to the PA. I can not find any 5/16" screws in the > hardware bag. I found two in the spares bag and two installed in the AC fuse > block. Checked everything else. Stephanie either missed it totally or the > manual is incorrect. Up to this point she has been spot on. > > Could this be an error where they really meant to use 3/16"? I tried 3/16" > and they have 4 to 5 threads into the heatsink. > > Suggestions? > > Thanks in advance, > > Dave Anderson, K4SV > Tryon, NC > 828 777-5088 > > www.K4SV.com > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
