What is the cure for an ERR BP2 in a K3? The manual says to de-install KBPF3 on the RF board. This sounds serious and complicated. Is this an error msg that must be fixed, or can it wait until our crew returns from a dxpedition? 73, George George Wagner, K5KG Sarasota, FL 941-400-1960 cell
____________________________________ From: [email protected] To: [email protected] CC: [email protected], [email protected], [email protected], [email protected], [email protected], [email protected], [email protected], [email protected], [email protected] Sent: 1/29/2012 4:31:44 P.M. Eastern Standard Time Subj: RE: PJ4 Sunday afternoon update. Got the 500hz filter installed and calibrated per the info from the factory. Installed the ext. RX board as well. All seems good at the moment. Bob/George, still getting the ERR BP2 at initial power up though. MD -----Original Message----- From: Bob Raymond, WA1Z [mailto:[email protected]] Sent: Sunday, January 29, 2012 7:26 AM To: <[email protected]> Cc: [email protected]; [email protected]; [email protected]; [email protected]; [email protected]; [email protected]; [email protected]; [email protected]; [email protected] Subject: Re: PJ4 Marty, what is the specific error code/message on the K3 display? > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
