I have a late model K2/100 that I mostly use on CW. In the past, I have made successful contacts on SSB, but haven't tried for 6 months or so. Last night, I was scanning the phone side of 20 meters and heard a dx station that I tried to contact. He never heard me. I then heard a local station and tried to get a signal report, but he could barely hear me and reported that I was dropping off badly.
I got suspicious and put an rf meter on the output. On CW, key down, I get the full 100 watts on 20 and 40. On SSB, when I speak loudly, I get a very short, low level output, that falls to nil almost immediately. The brief output is reading in the 10-15 dbm range--very low--and then it drops to a few dbm.* It smells like the ALC circuitry has gone south, and I will be investigating that in the next few days. However, if anyone has any suggestions as what other sections could cause this to occur, I would appreciate the heads up. Thanks in advance, *I am using an uncalibrated RF power meter (PIC power meter from recent QEX/QST articles) through a 40db tap. Although I need to calibrate the meter, it is relatively sensitive and appears to be "close" using default settings. In any event, the relative measurements, show that there is a significant problem on SSB but not on CW. HOWARD W. ASHCRAFT, Jr. W1WF Direct Dial: (415) 995-5073 [EMAIL PROTECTED] HANSON 333 Market Street, 23rd Floor BRIDGETT San Francisco, CA 94105-2173 MARCUS Direct: (415) 995-5073 VLAHOS Main: (415) 777-3200 RUDY, LLP Fax: (415) 541-9366 This communication, including any attachments, is confidential and is protected by privilege. If you are not the intended recipient, any use, dissemination, distribution, or copying of this communication is strictly prohibited. If you have received this communication in error, please immediately notify the sender by telephone or email, and permanently delete all copies, electronic or other, you may have. To ensure compliance with requirements imposed by the IRS, we inform you that any tax advice contained in this communication (including any attachments) was not intended or written to be used, and cannot be used, for the purpose of (i) avoiding penalties under the Internal Revenue Code or (ii) promoting, marketing or recommending to another party any transaction or matter addressed herein. The foregoing applies even if this notice is imbedded in a message that is forwarded or attached. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
