Hello All
I am new to the list
Have just started building my K2 Eric. Can't promise to screw it up but
no doubt I will call for help sometime.
One question. Just assembled the control board & carried out the
resistance checks. I did not find any shorts but some of the resistance
values did not match the figures given. I realise it will be tested
later but the instructions made no mention of what to check if the
resistances were not as specified.
Regards
Dave Lindsay GM4HQF G-QRP #2513
Aberdeen
---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 0528-3, 13/07/2005
Tested on: 14/07/2005 09:44:16
avast! - copyright (c) 1988-2004 ALWIL Software.
http://www.avast.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
