Joe, Thanks. I was looking at the actual manual and the pages didn,'t relate. Another post simplified what I was looking for. I appreciate your time to clarify the reference.
Bill K9YEQ "Joe Subich, W4TV" <[email protected]> wrote: On the K3 manuals page ... where it's been in various incarnations for some three years. http://www.elecraft.com/manual/K3_Schematics_Jun_2010.pdf 73, ... Joe, W4TV On 11/22/2011 9:04 PM, Bill K9YEQ wrote: > Joe, > > Out of passing interest I tried to find the references you made below > without success. Would you be so kind as to give me a direct link to the > schematic and the RF board. I need to consider my internal jumper to make > some SUB receiver changes to antenna connections. > > Thanks a bunch. > > 73, > Bill > K9YEQ > > -----Original Message----- > > Is there a diagram anywhere showing the internal connections to the RX> > ANT OUT jack? > > Page 38 (KXV3) and 39 (KXV3A) of the K3 schematics set on the Elecraft Web > site. It also helps to look at the RF Board (pg 4). > > 73, > > ... Joe, W4TV > > > On 11/22/2011 8:37 PM, Barry N1EU wrote: >> Is there a diagram anywhere showing the internal connections to the RX >> ANT OUT jack? >> >> It obviously isn't working as I expected. I thought RX ANT OUT would >> pass whichever of TX ANT or RX ANT that was not selected by the main >> rx. But with TX ANT used by main rx, RX ANT is not getting passed to >> RX ANT OUT as I expected it to be. >> >> Thanks& 73, >> Barry N1EU >> ______________________________________________________________ > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
