Hi All, I've taken Jim Brown and Don's advise and constructed a K2 to PC control cable using Shielded Cat 6 ethernet cable. The shield is tied to the DB9 shell on both ends of the cable, signal returns using the "striped wire" of each pair tied to pin 5.
The cable appears to be a success: RFI problems are much improved! Now I'd like to construct similar control cables for other gear in the shack: 1) The cable from the K2 to a remoted KPA100 2) The cable from the W1 to the PC 3) Cable from a SignaLink to the PC and K2 4) etc Many of the above cables do not seem to have a "return" line and/or do not use Pin 5. Assuming I'm still tying the shield to the DB9 shell, where should I tie the "striped wires" of each pair to? 73 Brian N5BCN ----- K2 #6800 KPA100/KAT100-2, KSB2, KAT2, KIO2, K160RX, KNB2, KAF2, LP-PAN/K2 w/ Pre-amp, SignaLink USB -- View this message in context: http://elecraft.365791.n2.nabble.com/OT-K9YC-s-Control-Cable-Part-Two-tp6810074p6810074.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
