BTW that was the menu on the P3, not the K3.
On 7/4/2011 7:03 AM, Roger Banks wrote: > Ok - here's one.... > New P3. K3 1 month old. Both factory built with internal 2m module, KXV3A > etc. > I have no IF display at all on the P3 on any band at any scale level. > Tried rescaling, everything on P3. I have changed IF lead. > If I put a freq counter on the IF out socket from the K3 I get nothing - is > this right? > Can it be switched on and off by the K3 software? I cannot see mention of > this anywhere. > RS232 works and displays freq on P3 OK. DSP widths are showing - everything > by IF signal data. > Any thoughts please? > Roger > GW4WND > > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/P3-no-IF-display-tp6546250p6546250.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
