Steve, That is old information that you were seeing. Those changes have been incorporated on your KSB2 - of course, if you purchased an older KSB2 board from another owner, you should check it physically against the values changed by that IMD mod. The mod instructions are on the Elecraft website.
Increase the audio level into the K2 until you see 1 ALC bar, and then back the audio off a bit until it disappears or just barely flickers. 73, Don W3FPR On 5/4/2011 3:52 PM, Steve_wG0AT wrote: > Getting ready to use my K2 SN6473 on PSK and possibly other data > modes. Wondering if there's any issues w/IMD on the K2? I seem to > remember seeing somewhere on the web a mod made to the SSB board? or > was that just early SN K2s? Or if I just watch my gain/power levels to > avoid any ALC should I be OK? > > Tks, Steve wGOAT > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
