----- Original Message -----
From: "Tom Hammond" <[EMAIL PROTECTED]>
To: " "RC" KC5WA" <[EMAIL PROTECTED]>; <[email protected]>
Sent: Thursday, June 02, 2005 3:13 PM
Subject: [Elecraft] Installing the K2 TILT BAIL - The easy way!
Hi Folks:
At 10:20 AM 6/2/2005, \"RC\" KC5WA wrote:
I have reached that portion in the RF Board Assembly
titled "Alignment and Test, Part I" on page 42. Everything
to this point has been a breeze ( exception being the Tilt
Bail, [it took an hour to install] which I believe was
designed to satisfy a designers twisted mind [g] )
"rc" kc5wa
I've posted this method several times over the past several years, but it
appears that another posting might be in order.
One of the true TESTS of the Elecraft builder's good nature is the
installation of one of those (damned) tilt bails!!! They are terribly
stiff and will try anyone's patience.
After a couple years of periodic frustration, here's how I now do it...
One of the worst parts of installing the front feet and tilt bail on is
trying to fight the bail while having such a small amount of working
distance between the bottom cover of the radio and the feet. So...
Initially, DO NOT use the 4-40 x 7/16" screws specified in the assembly
manual. Find (somewhere) four (4) 4-40 x 1" screws and use them to install
the feet AND the bail... this extra length gives you MORE than ample
'fighting room' when you are installing the bail. Once the long screws
have been snugged down, and the feet and bail have been properly seated,
replace (one-at-a-time) each of the longer 4-40 screws with the 4-40 x
7/16" screws specified in the manual. Since the feet and bail will be held
securely in place by the remaining (already tightened) screws, replacement
will be a snap and you won't have that overwhelming urge to heave the
radio (or at least the bottom cover) up against the wall.
Works fer me!
73,
Tom Hammond N0SS
Nice idea but why all the fuss? I just squeezed the
ends before installation. It took only 1 try to find
the balance between "easy to install" and "stays
put (up or down)".
The bonus is that my bail dosen't thump the bottom
of the rig too hard when I put it up yet stays in
place just fine, up or down.
Still, clever idea with the screws.
--
Just my 2¢ worth... 73's es gd dx de Ken KGØWX
Grid EM17ip, Flying Pigs #-1055, Digital On Six #350,
Proud builder & owner of Elecraft K2 #4913
--
Checked by AVG Anti-Virus.
Version: 7.0.322 / Virus Database: 267.4.1 - Release Date: 6/2/2005
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
