The PIC18F8722 microcontroller used has 128KB of flash program memory and a bit less than 4KB of RAM. Its a Harvard architecture machine, not the Von Neumann model. Your "simple" suggestion is infeasible. There is no place on chip to buffer the firmware in its entirety.
Dick, K6KR On Feb 6, 2011, at 14:53, Ross Primrose N4RP <[email protected]> wrote: > On 2/6/11 3:36 PM, Don Wilhelm wrote: >> I do not know how any additional degree of "robustness" in K3 Utility >> could correct for that condition. >> > > Simple... Don't write ANYTHING to the K3 EEPROM (I assume) until the K3 > has received the ENTIRE firmware file w/o errors. Blocks with errors can > always be resent.... > > 73, Ross N4RP > > -- > FCC Section 97.313(a) “At all times, an amateur station must use the minimum > transmitter power necessary to carry out the desired communications.” > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
