Is that what you read on the K3 front panel display?
On Tue, Nov 23, 2010 at 4:20 PM, Mike Harris <[email protected]> wrote: > 13.8V from an Alinco DM-330MW switcher > > Mike VP8NO > > ----- Original Message ----- From: "Guy Olinger K2AV" > <[email protected]> > To: "Mike Harris" <[email protected]> > Cc: <[email protected]> > Sent: Tuesday, November 23, 2010 6:04 PM > Subject: Re: [Elecraft] K3 LEDs light up, but won't come to life > > > What is the power supply supply voltage? 73, Guy. > > On Tue, Nov 23, 2010 at 3:58 PM, Mike Harris <[email protected]> wrote: >> >> Hi, >> >> I've started to notice this in the past couple of months. I turn >> the PSU off for a few seconds, then back on and all is OK. It has >> happened maybe a dozen times. >> >> Regards, >> >> Mike VP8NO >> >> ----- Original Message ----- >> From: "Eric Rosenberg" <[email protected]> >> To: <[email protected]> >> Sent: Tuesday, November 23, 2010 5:49 PM >> Subject: [Elecraft] K3 LEDs light up, but won't come to life >> >> >>> thi has happened three times: >>> >>> I turn on the K3, the LEDs on the four knobs under the display >>> light up, but >>> the display stays dark and I cannot power it off with the power >>> button. >>> >>> I have to disconnect the power, wait a little bit and re-connect >>> the radio. >>> It comes back to life when I power it on. >>> >>> What's happening? >>> >>> Eric W3DQ >>> Washington, DC > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
